Sun Microsystems SunFastEthernet Adapte - Manual (Page 45)

Installing SunFastEthernet Software Using Solaris 1.x 3-17
3
If you are on a SunOS 4.1.3 machine use 4.1.3 in place of OSVER, for releases
later than SunOS 4.1.3 use 4.1.3_U1 in place of OSVER. Enter the following
commands:
Add the following lines to SYS/sun4m/conf/files:
Add the following lines to the configuration file that you use for building
diskless client kernels:
Now use the config command to rebuild the system configuration files for the
diskless client. You can now copy the new kernel over to the diskless clients.
You need to remember to add the SunFastEthernet interface names to /etc/hosts
for each diskless client, and add the names of all the new interfaces to NIS if
you are using it. The name of the SunFastEthernet interface will become the
official hostname for the diskless clients. If you do not want this to happen,
then use the SunFastEthernet install script to do an install on one machine and
copy the changes made to /etc/rc.boot to the other diskless clients.
# cp /usr/BQE/OSVER/sys/sunif/* SYS/sunif
# cp /usr/BQE/OSVER/sys/sun4m/OBJ/* SYS/sun4m/OBJ
# cp SYS/sun4m/conf/files SYS/sun4m/conf/files.prebqe
#
# SunFastEthernet and SBus Quad Ethernet Controller
#
sunif/if_qec.c optional qec
sunif/if_bqe.c optional bqe
#
# SunFastEthernet and SBus Quad Ethernet Controller
#
device-driver qec
device-driver bqe