70 appendix – Siemens Gigaset C100 DECT User Manual
Page 71
70
Appendix
Gigaset C100 / englisch / A31008-C100-J101-1-7619 / appendix.fm / 24.06.2003
… the incoming call number is
not displayed even though
CLIP is set?
Calling line identification is not
enabled.
The caller should ask his net-
work provider to enable the
identification of his number
(CLI).
… I hear an error tone (falling
tone sequence) when keying
an input?
The action has failed or the input
is incorrect.
Repeat the procedure; watch
the display and if necessary
refer to the operating instruc-
tions.
… I cannot listen to the net-
work mailbox.
Your phone system is set for
pulse dialling.
Set your phone system to tone
… the caller list does not indi-
cate a time for a message?
Date/time are not set.
Set the date/time (page 14).
… the answering machine
reports "PIN is incorrect" dur-
ing remote operation?
The entered system PIN is incor-
rect or set to 0000.
Enter the system PIN again or
set a PIN that is different from
… the answering machine
does not record any messages
or has automatically switched
over to 'announce only'?
The memory is full.
Delete old messages
Play back and delete new mes-
sages.
What has happened
when …
Possible cause
Possible solution