Siemens Gigaset C100 DECT - Manual (Page 68)

67
Connecting the base to a PABX
Gigaset C100 / englisch / A31008-C100-J101-1-7619 / pabx.fm / 24.06.2003
Connecting the base to a PABX
The following settings are only needed when your PABX requires them, please refer to
the operating instructions for your PABX.
Dialling modes and recall
The current setting is indicated by ‰ .
Step 1: Changing the dialling mode
The following dialling modes can be set:
◆ Tone dialling (DTMF),
◆ Dial pulsing (DP),
◆ DTMF earth (country-specific).
Step 2: Setting the recall
i
You cannot send or receive text messages on PABX's that do not support
Calling Line Identification.
[_______________] MENU
Press the display key to open the menu.
[__________] [_____________________________________________________________] Base Settings
[_________] OK
Select the menu item and confirm.
[__________] [_____________________________________________________________] Additional Features
[_________] OK
Select the menu item and confirm.
[_____________________________________________________________] [__________] Dialling Mode OK
Confirm.
[__________] [_________] OK
Select the dialling mode and confirm.
Long press (back to idle status).
[_______________] MENU
Press the display key to open the menu.
[__________] [_____________________________________________________________] Base Settings
[_________] OK
Select the menu item and confirm.
[__________] [_____________________________________________________________] Additional Features
[_________] OK
Select the menu item and confirm.
[__________] [_____________________________________________________________] Recall
[_________] OK
Select the menu item and confirm.
[__________] [_________] OK Select recall and confirm.
Long press (back to idle status).