Siemens Gigaset C100 DECT - Manual (Page 66)

65
Setting the base
Gigaset C100 / englisch / A31008-C100-J101-1-7619 / settings_bs_hs.fm / 24.06.2003
Repeater support
With a repeater you can increase the range and reception strength of your base; the
repeater must be registered. To use the repeater you must first activate the repeater
mode. This will cancel any calls that are in progress.
Restoring the base factory settings
Resetting does not affect the system PIN and handsets are still registered.
[_______________] MENU
Press the display key to open the menu.
[__________] [_____________________________________________________________] Base Settings
[_________] OK
Select the menu item and confirm.
[__________] [_____________________________________________________________] Additional Features
[_________] OK
Select the menu item and confirm.
[__________] [_____________________________________________________________] Repeater Mode
[_________] OK
Select the menu item and confirm (
‰
= On).
[________] OK Press the display keyto confirm the prompt.
Long press (back to idle status).
[_______________] MENU Press the display key to open the menu.
[__________] [_____________________________________________________________] Base Settings
[_________] OK
Select the menu item and confirm.
[__________] [_____________________________________________________________] Base Reset
[_________] OK
Select the menu item and confirm.
[_______] OK
Enter the system PIN (the factory setting is 0000)
and confirm.
[________] OK
Press the display keyto confirm the prompt.