Siemens Gigaset C100 DECT - Manual (Page 69)

68
Connecting the base to a PABX
Gigaset C100 / englisch / A31008-C100-J101-1-7619 / pabx.fm / 24.06.2003
Setting pauses
Changing the pause after line seizure
You can set the length of the pause that is inserted between pressing the top half of the
c
key and the transmission of the telephone number (the default setting is 3 seconds).
Change pause after Recall key
You can change the length of the pause if your PABX requires this (refer to the operating
instructions for your PABX; the default setting is 800 ms).
Changing the dialling pause
Switching temporarily to tone dialling (DTMF)
If your PABX still operates with dial pulsing (DP) but tone dialling (DTMF) is required for
a particular call (e.g. to check your network mailbox), you must switch to tone dialling
during the call.
Precondition: A call is in progress.
[______________] MENU Press the display key to open the menu.
Press keys.
[_______] OK
Enter a number for the length of the pause
(1 = 1 sec.; 2 = 3 sec.; 3 = 7 sec.; 4 = 2.5 sec.)
and confirm.
[______________] MENU
Press the display key to open the menu.
Press keys.
[_______] OK
Enter a number for the length of the pause
(1 = 800 ms; 2 = 1600 ms; 3 = 3200 ms)
and confirm.
[______________] MENU
Press the display key to open the menu.
Press keys.
[_______] OK
Enter a number for the length of the pause
(1 = 1 sec.; 2 = 2 sec.; 3 = 3 sec.; 4 = 6 sec.)
and confirm.
[______________] MENU
Press the display key to open the menu.
[__________] [_____________________________________________________________] Tone dialing
[_________] OK
Select the menu item and confirm. Tone dialling is
now activated for this call.