Siemens Gigaset C100 DECT - Manual (Page 70)

69
Appendix
Gigaset C100 / englisch / A31008-C100-J101-1-7619 / appendix.fm / 24.06.2003
Appendix
Care
Wipe the base and the handset with a damp cloth (use no solvent) or an antistatic cloth.
Never use a dry cloth as this can cause static discharge!
Contact with liquid
If the handset should come into contact with liquid, on no account switch the device
on. Remove all batteries immediately.
Allow the liquid to drain out of the device, and then pat all parts of the device dry.
Keep the handset with the batteries removed in a warm, dry place for at least 72 hours.
In many cases, you will then be able to use it again.
Questions and Answers
If you have any questions about the use of your phone, you can contact us 24/7 at
www.my-siemens.com/customercare. You will find the most frequently asked ques-
tions and answers below.
!
What has happened
when …
Possible cause Possible solution
… the display is blank? The handset is not switched on.
The batteries are flat.
Press the 'end call' key
a
for
around 2 sec..
Charge or replace the batteries
(page 9).
… the handset fails to respond
to a key press?
The keypad lock is activated. Press the hash key
R
for
around 2 sec. (page 10) to
deactivate the lock.
… "Base x" flashes in the dis-
play?
The handset is outside the range
of the base.
The base is not switched on.
Move the handset nearer to the
base.
Check the power connector at
the base (page 7).
… an internet address appears
in the display?
The automatic registration of
your handset to the base has
been interrupted.
Register your handset manu-
ally (page 53).
… (when using more than one
handset) the handset that is in
the base does not charge?
The base will not charge the
handset if telephoning is simul-
taneously in progress.
Use an additional charger.
… the handset or the base
C 150 does not ring?
The ringer is switched off.
Call Diversion is set to All Calls.
Switch on the ringer in the
handset (page 59) or base
C 150 .
Switch off Call Diversion
(page 20).
… I can hear no ringer tone/
dial tone?
You have changed the telephone
cord on your Gigaset.
When purchasing a new cord
ensure that it has the correct
pin assignment (page 7).
… the other party cannot hear
me?
You have pressed the INT key.
This mutes the handset.
Switch on the microphone
again (page 18).