beautypg.com

Scanning for the first time, Scanning for the first time -6 – Symbol Technologies SPS 3000 Series User Manual

Page 43

background image

4-6

SPS 3000 Series Programmer’s Guide

Scanning For the First Time

Note: Depending on how your system is configured during installation of

the scan driver CAB file, the physical Compaq® iPAQ application
button that starts the Trigger application and the scanning
application launched may vary.

The information in this section assumes that the Trigger application
is mapped to Button 5, the Record Button (see

iPAQ Pocket PC

Parts Used by the SPS 3000

on page 1-3), and that the ScanWedge

application is set to launch automatically.

To scan using the SPS 3000:

1.

Insert the iPAQ into the SPS 3000 (see

Inserting the iPAQ into the SPS 3000

on

page 2-1).

2.

Press the scan trigger (Record Button) to launch the Trigger system tray
application.

3.

When the Trigger application’s About box is dismissed (either manually or
automatically), ScanWedge launches.

4.

Press the scan trigger a second time. This turns on the laser, which produces a red
scan beam. Verify that the red scan beam covers the entire 1-D bar code. If the bar
code is decoded, an audible beep occurs. ScanWedge places the bar code data in
any valid input field (any field that accepts cursor input).

Figure 4-5. Scanning a Bar Code

Scan Trigger (Default)
“Record Button”