beautypg.com

Wlan drivers cab files – Symbol Technologies SPS 3000 Series User Manual

Page 35

background image

3-6

SPS 3000 Series Programmer’s Guide

The following files are installed by the scndrv_xxxx.cab file:

WLAN Drivers CAB Files

landrvarm_xxxx.cab
This CAB file must be installed in order to use the WLAN capabilities of an SPS
3000 that contains WLAN hardware. After the drivers are installed, a warm boot of
the system must take place. A warm boot is initiated by pressing the Reset button
located on the bottom of the iPAQ (see

iPAQ Pocket PC Parts Used by the SPS

3000

on page 1-3).

landrvdiv_xxxx.cab
The WLAN hardware on the SPS 3000 contains a single antenna. This CAB file
configures the WLAN driver not to use “Diversity” and sets the hardware default to
not use “Diversity”.

Note: When CAB files are registered, the “xxxx” in each CAB file name

(described in the sections,

Scan Drivers and Applications CAB Files

and

WLAN Drivers CAB Files

) is replaced with a number that

corresponds to the CAB file’s release revision. This provides an
easy way to tell if the most current revision of the CAB file is used.
For example, scndrv_0100.cab corresponds to a CAB file version of
1.00.

SpexPDD.DLL

Scanner ASIC device driver. This file is copied to the
“\Windows” directory.

ScanMDD.DLL

Scanner stream device driver. This file is copied to the
“\Windows” directory.

Scnapi32.DLL

Scanner API. This file is copied to the “\Windows” directory.

Trigger.exe

A system tray application that allows a hardware application
button to be used to trigger scanning operations. This
application can also be used to launch registered scanning
applications when the button is pressed. This executable is
copied to the “\Program Files\Scanner Files” directory.

Ctlpanel.exe

A sample application that provides an interface for modifying
scan parameters. This file is copied to the “\Program
Files\Scanner Files” directory.