Connecting to a power source, Power-over-ethernet connections -2, Figure 3-8 – SMC Networks SMC TigerStack III SMC6826MPE User Manual

Page 52: Power socket -12

NSTALLING

THE

WITCH

3-12

Connecting to a Power Source

To connect a switch to a power source:

1. Insert the power cable plug directly into the AC socket located at the

back of the switch.

Figure 3-8 Power Socket

2. Plug the other end of the cable into a grounded, 3-pin socket, AC

power source.

Note: For international use, you may need to change the AC line cord.

You must use a line cord set that has been approved for the socket
type in your country.

3. Check the front-panel LED indicators as the device is powered on to

be sure the PWR LED is lit. If not, check that the power cable is
correctly plugged in.

4. If you have purchased a Redundant Power Supply, connect it to the

device and to an AC power source now, following the instructions
included with the package.

100-240V~
50/60Hz 8.0-2.0A