SMC Networks SMC TigerStack III SMC6826MPE - Manual (Page 48)

I
NSTALLING THE
S
WITCH
3-8
Installing an SFP Transceiver
Figure 3-5 Installing an SFP Transceiver
The SFP slots support the following optional SFP transceivers:
• 1000BASE-SX
• 1000BASE-LX
• 1000BASE-LH
To install an SFP transceiver, perform the following steps:
1. Consider your network and cabling requirements to select an
appropriate SFP transceiver type.
2. Insert the transceiver with the optical connector facing outward and
the slot connector facing down. Note that SFP transceivers are keyed
so they can only be installed in one orientation.
3. Slide the SFP transceiver into the slot until it clicks into place.
Note: SFP transceivers are hot-swappable. The switch does not need to
be powered off before installing or removing a transceiver.
However, always first disconnect the network cable before
removing a transceiver.
Note: SFP transceivers are not provided in the switch package.
22
23
24
23
24 Link/Act
PoE
25
26
Pwr
Diag
Stack
Mode
PoE /Link
RPS