Siemens BUSINESS CLASS 5935 - Manual (Page 44)

SIEMENS 5930/5935 Business Gateway
User’s Guide Chapter 4 User Setup
Access Control
SIEMENS 38
Access Control
Restrict administrative control of the router to a specific set of IP addresses on the Access Control page. Each
remote access method (Telnet, Web, and SNMP) can be configured separately.
To set Access Control parameters:
1. Click Access Control from the left navigation pane of the Router Information page. This displays the
Access Control page.
2. Optionally, select one or more of the following remote access methods to enable that method of remote
access. A check in the box next to the method specifies enabled. If disabled, any access restriction
specification is disregarded.
• Telnet
• Web
• SNMP
3. For each remote access method selected, specify any access restrictions. This can be one of the
following:
• No access restrictions:
Remote access method is enabled and not restricted. This setting allows access from all hosts.
• Allowed from LAN:
Limits access to the host from the LAN.
4. Optionally select Allow System Logging to Syslog Servers. If selected, specify any access restrictions. This
can be one of the following:
• No access restrictions:
System Logging is not restricted. This setting allows access from all servers.
• Allowed from LAN:
Limits access for System Logging to servers on the LAN.
5. Click Save and Reboot.