Siemens BUSINESS CLASS 5935 - Manual (Page 29)

SIEMENS 5930/5935 Business Gateway
User’s Guide Chapter 3 Easy Setup
Select Protocol
SIEMENS 23
Point-to-Point Protocol over Ethernet over PPPoA
If you selected Point-to-Point Protocol over Ethernet over PPPoA from the Wan Interface page, the Point-
to-Point Protocol over Ethernet over PPPoA page is displayed when you click Next.
To configure Point-to-Point Protocol over Ethernet over PPPoA:
1. Enter PPPoE User Name and Password to use for authentication when establishing a WAN connection
using PPPoE protocol.
2. In Service Name, enter the domain name of your network service provider. Use * as a default (for all
services).
3. In PPPoE Timer, enter the number of seconds of inactivity that must elapse before the PPP connection
closes. This helps to limit connection charges from your service provider during times of inactivity. The
default entry of “permanent” will keep the PPP connection open constantly, with no time out interval.
4. Optionally select PPPoE only Filter. When selected, all traffic on the bridge is filtered to allow PPPoE
only. Select this option if you will only connect to your network service using PPPoE.
5. If you are using PPPoE over PPPoA, enter the PPPoA Username and Password.
6. Click Next. This displays the Dynamic Host Configuration Protocol page.