Woodstock SHOP FOX W1678 - Manual (Page 27)

-25-
Figure 46. Main power ON/OFF safety switch.
Figure 47. DO NOT stand in the path of where
the workpiece could be projected.
To use the double drum sander, do these
steps:
1. Twist and pull the emergency stop switch
knob, and position your finger over the knob.
Be ready to push the knob and shut the sander
OFF if there is a problem. See Figure 46.
2. Push the sanding drum ON button and listen
for any unusual noises. The sander must run
smoothly with little or no vibration.
• If unusual noise or vibration exists, push the
emergency stop switch immediately and
unplug the sander.
• Troubleshoot the source of the noise or
vibration, and correct the problem.
• ONLY adjust the sander when it is OFF and
unplugged.
• ONLY restart the sander when you are sure
the problem is corrected.
3. Start your dust collector.
4. Place the workpiece on the conveyor table
and turn the table height handwheel
clockwise to raise the conveyor table until
the stock barely touches the pressure roller.
See Figure 48.
5. Push the feed motor ON button to start the
feed conveyor.
6. See Figures 48 and 49 and feed the workpiece
correctly where the conveyor cannot pinch
your fingers.
NOTICE
ALWAYS take a few moments to listen and
observe for unusual noise and vibration after
starting the Double Drum Sander.
DO NOT stand in the path where the workpiece
could be projected. If you ignore this warning
you could be severely injured or killed!
Figure 48. NEVER hold the workpiece where the
conveyor and workpiece can pinch your fingers.
OPERATIONS