Troubleshooting, When connecting two components in series – JVC GET0602-001A User Manual
Page 136
6
JVC
CD
JVC
CD
CD-CH
CH-X1500
JVC
•
KS-BTA200
iPod
iPod
KS-PD100
KS-U57
3.5 mm
AUX
KS-U58
2
Connecting the external components to the CD changer jack /
CD
When connecting the external components, refer also to the manuals supplied for the components and
adapter.
CAUTION:
Before connecting the external components, make sure that the unit is turned off.
You can connect the following JVC components to the CD changer jack.
JVC component
Model name
CD changer (CD-CH)
CH-X1500, etc.
You can also connect the following components through the various JVC adapters.
• Connection cords may need to be purchased separately.
Component
Adapter
Model name
Bluetooth device
Bluetooth adapter
KS-BTA200
iPod
Interface adapter for iPod
KS-PD100
Portable audio player with line output jacks
Line input adapter
KS-U57
Portable audio player with 3.5 mm stereo mini jack
AUX input adapter
KS-U58
When connecting more than one component (maximum: two), it is recommended that you connect the
components in series as explained below.
E
To disconnect the connector /
Hold the connector top tightly (
1
), then pull it out (
2
).
1
2
When connecting two components in series
A
KS-BTA200
B
*
7
CD-CH / KS-PD100 / KS-U57 / KS-U58
CD changer jack / CD
*
7
To use these components, set the external input setting correctly (see page 16 of the INSTRUCTIONS).
*
7
16
TROUBLESHOOTING
• The fuse blows.
* Are the red and black leads connected correctly?
• Power cannot be turned on.
* Is the yellow lead connected?
• No sound from the speakers.
* Is the speaker output lead short-circuited?
• Sound is distorted.
* Is the speaker output lead grounded?
* Are the “–” terminals of L and R speakers grounded in common?
• Noise interfere with sounds.
* Is the rear ground terminal connected to the car’s chassis using shorter and thicker cords?
• This unit becomes hot.
* Is the speaker output lead grounded?
* Are the “–” terminals of L and R speakers grounded in common?
• This unit does not work at all.
* Have you reset your unit?
•
*
•
*
•
*
•
*
*
L
R
–
•
*
•
*
*
L
R
–
•
*
*
7
CT_Instal_KW-AVX726[UT]2.indb 6
CT_Instal_KW-AVX726[UT]2.indb 6
08/12/25 16:33:31
08/12/25 16:33:31