E3 and t3 bnc connector pinout, Adsl and g.shdsl rj-11 connector pinout, 238 adsl and g.shdsl rj-11 connector pinout – Juniper Networks J-series Services Router J2320 User Manual
Page 260
Table 90: RJ-48 Connector to DB-15 Connector (Crossover) Pinout (continued)
Signal
DB-15 Pin
(Data Numbering
Form)
RJ-48 Pin (on T1/E1 PIM)
(Data Numbering Form)
No connect
No connect
7
No connect
No connect
8
No connect
No connect
9
No connect
No connect
10
No connect
No connect
11
No connect
No connect
12
No connect
No connect
13
No connect
No connect
14
No connect
No connect
15
E3 and T3 BNC Connector Pinout
The E3 and T3 PIMs each use two BNC connectors—one for transmitting data (
TX
)
and one for receiving data (
RX
).
ADSL and G.SHDSL RJ-11 Connector Pinout
The 1-port ADSL 2/2+ Annex A and Annex B PIMs use an RJ-11 cable, which is not
supplied with the PIMs. The 2-port G.SHDSL Annex A and Annex B PIM also uses an
RJ-11 cable, which is not supplied with the PIM. Table 91 on page 238 describes the
RJ-11 connector pinout.
Table 91: ADSL and G.SHDSL RJ-11 Connector Pinout
Signal
Pin
No connect
1
No connect
2
RJ P –Tip
3
RJ N –Ring
4
No connect
5
No connect
6
238
■
E3 and T3 BNC Connector Pinout
J2320, J2350, J4350, and J6350 Services Router Getting Started Guide