J4350 and j6350 field-replaceable pim summary – Juniper Networks J-series Services Router J2320 User Manual
Page 69

Table 19: J2320 and J2350 Field-Replaceable PIM Summary
Sample Interface Name
(type-pim/0/port)
Port Numbering
Supported Software Releases
for This PIM
PIM
ge-2/0/0
Ports:
■
0
■
0 through 5
■
0 through 7
■
0 through 15
JUNOS 8.4 and later
1-Port SFP, 6-Port SFP,
8-Port, and 16-Port
Gigabit Ethernet uPIMs
se-3/0/1
Ports—0 and 1
JUNOS 8.4 and later
Dual-Port Serial PIM
t1-0/0/1
or
e1-0/0/1
Ports—0 and 1
JUNOS 8.4 and later
Dual-Port T1 or E1 PIM
ct1-0/0/0
ce1-0/0/0
Ports—0 and 1
JUNOS 8.4 and later
Dual-Port Channelized
T1/E1/ISDN PRI PIM
br-1/0/2
Ports—0, 1, 2, and 3
JUNOS 8.4 and later
4-Port ISDN BRI PIM
at-2/0/0
Port—0
JUNOS 8.4 and later
ADSL PIM
at-1/0/0
Ports—0 and 1
JUNOS 8.4 and later
G.SHDSL PIM
J4350 and J6350 Field-Replaceable PIM Summary
Table 20 on page 48 provides software release information, slot and port numbers,
and sample interface names for the field-replaceable PIMs supported on J4350, and
J6350 Services Routers.
CAUTION: Do not install a combination of PIMs in a single chassis that exceeds the
maximum power and heat capacity of the chassis. If J-series power management is
enabled, PIMs that exceed the maximum power and heat capacity remain offline
when the chassis is powered on.
To verify that the combination of PIMs to be installed in a chassis does not exceed
the power and heat capacities for the J4350 or J6350 router, see “Planning for Power
Management” on page 112.
Field-Replaceable PIMs
■
47
Chapter 3: PIM and VoIP Module Overview