Juniper Networks T1600 - Manual (Page 143)

• SONET/SDH framing
• Link aggregation
• Alarm and event counting and detection
• Dual-router automatic protection switching (APS)
• Multiprotocol Label Switching (MPLS) fast reroute
• Encapsulations:
• Circuit cross-connect (CCC)
• Translational cross-connect (TCC)
• Frame Relay
• High-Level Data Link Control (HDLC)
• Point-to-Point Protocol (PPP)
• Optical diagnostics and related alarms
• Laser bias
• Transmit optical power
• Receiver optical power
• Laser temperature
Software features
• Duplex SC/PC connector (Rx and Tx)
• SONET/SDH OC768c/STM265 Short reach (SR-1) fixed transceiver
Optical interface specifications—see SONET/SDH OC768/STM256 Optical Interface
Specifications
NOTE: To extend the life of the laser, when a PIC is not being actively used with any valid links,
take the PIC offline until you are ready to establish a link to another device. For information about
taking a PIC offline, see the
request chassis pic offline command in the Junos OS Operational Mode
Commands.
Cables and connectors
One tricolor per port:
• Off—Not enabled
• Green—Online with no alarms or failures
• Yellow—Online with alarms for remote failures
• Red—Active with a local alarm; router has detected a failure
LEDs
143 Copyright © 2013, Juniper Networks, Inc.
SONET/SDH OC768c/STM256 PIC (T1600 Router)