Intel SHG2 - Manual (Page 34)

34 Intel Server Board SHG2 Product Guide
3. Attach the air intake fan assembly to the side of the heat sink wind tunnel closest to the front of
the chassis.
a. Press both sides of the air intake section to bend tabs inward (see 1 in Figure 18).
b. Insert tabs into slots on the wind tunnel center section (see 2 in Figure 18).
c. Press the air intake section downward to engage the assembly (see 3 in Figure 18).
OM14371
1
1
2
3
Figure 18. Attaching the Wind Tunnel Intake and Exhaust
4. Attach the air exhaust fan assembly to the heat sink wind tunnel.
a. Press both sides of the air exhaust section to bend tabs inward (see 1 in Figure 19).
b. Insert tabs into slots on the wind tunnel center section (see 2 in Figure 19).
c. Press the air intake section downward to engage the assembly (see 3 in Figure 19).
OM14374
1
1
2
3
Figure 19. Attaching the Wind Tunnel Intake and Exhaust
5. Attach CPU Fan cable(s). See the next section “Making Connections to the Server Board” for
fan connector location information.