Add-in board connectors, Video – Intel SHG2 User Manual

Page 13

Description 13

Add-in Board Connectors

The server board has the following add-in board connectors:
• Two 184-pin full-length, 3.3 V, PCI-X 64-bit/100 MHz connectors.
• Three 120-pin full-length, 5 V, standard PCI 32-bit/33 MHz connectors.
• One 184-pin full-length, 3.3 V, connector that is capable if PCI-X 64-bit/133 MHz operation.

To enable PCI-X 64-bit/133 MHz operation, you must disable the onboard SCSI controller
using BIOS Setup. See page 57 for more information on using BIOS Setup. The default
operation of this connector (slot 6) is PCI 64-bit/66 MHz operation.

Video

The system has an integrated ATI Rage XL 32-bit high-performance SVGA subsystem that
supports the following:
• BIOS compatibility with all standard VGA modes
• 8 MB of video memory
• Pixel resolutions up to 1600 x 1200 pixels per inch (ppi) in 8/16/24/32 bpp modes under 2D

and up to 1024 x 768 ppi in 8/16/24/32 bpp modes under 3D

• Both CRT and LCD monitors up to 100 Hz vertical refresh rate

Table 2.

Video Modes

SHG2 2D Mode Video Support

2D Mode

Refresh Rate (Hz)

8 bpp

16 bpp

24 bpp

32 bpp

640x480

60, 72, 75, 90, 100

Supported

800x600

60, 70, 75, 90, 100

Supported

1024x768

60, 72, 75, 90, 100

Supported

1280x1024

43, 60

Supported

1280x1024 70,

Supported

– Supported

Supported

1600x1200

60, 66

Supported

1600x1200 76,

Supported

–

3D Mode

Refresh Rate (Hz)

SHG2 3D Mode Video Support with Z Buffer Enabled

640x480

60, 72, 75, 90, 100

Supported

800x600

60, 70, 75, 90, 100

Supported

1024x768

60, 72, 75, 90, 100

Supported

1280x1024

43, 60, 70, 72

Supported

–

1600x1200

60, 66, 76, 85

Supported

–

3D Mode

Refresh Rate (Hz)

SHG2 3D Mode Video Support with Z Buffer Disabled

640x480

60, 72, 75, 90, 100

Supported

800x600

60, 70, 75, 90, 100

Supported

1024x768

60, 72, 75, 90, 100

Supported

1280x1024

43, 60, 70, 72

Supported

–

1600x1200

60, 66, 76, 85

Supported

–