Interphase Tech iSPAN 5535 PRI - Manual (Page 95)

Chapter 7: Troubleshooting
iSPAN PRI PCI ISDN Users Guide 75
RAS initialization
failed in the
driver-event log Look up the failure cause in your Microsoft RAS
documentation.
No valid
configuration
message in
SynWatch
configuration
panel
1. Check whether the adapter and the associated
drivers are installed correctly. (See Index of
Common Tasks on page 115.)
2. In the WAN Adapter Setup program, check that
the ISDN Layer is present in the adapter microcode.
CSU activation
failed at load time If a message appears at load time informing you that
the CSU activation failed, you probably entered an
invalid password for CSU activation.
Enter the password again to activate the CSU and
reload. See Editing DS1 Properties (North America
Only) on page 58 for additional information.
Problem Possible Solution(s)