Interphase Tech iSPAN 5535 PRI User Manual
Page 115
Appendix C: Using the LoopTest Utility
iSPAN PRI PCI ISDN Users Guide
95
Driver Not
Loaded
The adapter driver was not in a working state when
LoopTest was launched. Possible causes are:
• The adapter is not installed.
• The driver is not installed, or is improperly installed.
• The firmware is invalid (ISDN layer not present) or
not loaded. To check the firmware status:
a. From the Start menu, select Programs, then
INTERPHASE WAN Adapters, and then WAN
Setup.
b. See if the microcode is loaded (LEDs must be
green), and check its characteristics (ISDN layers
must appear).
Driver access
denied
This error occurs in the following situations:
• You are executing more than the maximum 15
instances of LoopTest.
• The driver is not installed, or is improperly installed.
Connection failed
The connection cannot be established, and the ISDN
network has not supplied a reason. This error generally
occurs when the dialing number is wrong.
ERROR:
Connection cut
off
The connection was cut off during data exchange with
no notification from or to the network. This error
generally occurs when the ISDN cable is removed
during testing.
Message
Cause