Intel Express 5800/120Ld - Manual (Page 95)

Dissasembly and Reassembly 4-23
Hard Disk Drives
The system supports a variety of SCSI hard disk drives installed in the system’s
hard disk drive bay. The SCSI hard disk drive bay in the system is one of two
types: a standard SCSI disk drive bay or a hot-swap SCSI disk drive bay.
Refer to Figure 4-18 to identify the type of hard disk drive bay in the system. In
each example the internal hard disk drives are located in the SCSI disk drive
bays.
0 1 2 3 4 5
Hot-Swap Hard Disk Drive Bays
0 1 2 3 4 5
Standard Hard Disk Drive Bays
Figure 4-18. SCSI Disk Drive Bays
If you are adding or removing a SCSI hard disk device, consider the following:
! CAUTION
Do not hot swap a non-LVD-disk-drive into a LVD-disk-drive
only system for it may cause data corruption. The only way a
non-LVD-disk-drive can be used with an all LVD-disk-drive
system is by first powering down the system, installing the
non-LVD-disk-drive, and then powering the system back up.
Note: Installing a non-LVD-disk-drive into an all LVD-
disk-drive system causes all the drives to operate in the non-
LVD mode