Diagnostic error codes – IBM x Series 200 User Manual
Page 97

Symptom-to-FRU index
89
Diagnostic error codes
Note:
In the following error codes, if XXX is 000, 195, or 197,do not replace a FRU.
The description for these error codes are:
000
The test passed.
195
The
Esc
key was pressed to abort the test.
197
This is a warning error and may not indicate a hardware failure.
For all error codes, replace/follow the FRU/Action indicated.
No ac power
1.
Check the power cord.
2.
Power supply.
No beep and no video
1.
See “Undetermined problems” on page 100
Error Code/Symptom
FRU/Action
001-XXX-000
(Failed core tests)
1.
System Board
001-XXX-001
(Failed core tests)
1.
System Board
001-250-000
(Failed System Board ECC)
1.
System Board
001-250-001
(Failed System Board ECC)
1.
System Board
005-XXX-000
(Failed Video test)
1.
Video Adapter (if installed)
2.
System Board
011-XXX-000
(Failed COM1 Serial Port test)
1.
System Board
011-XXX-001
(Failed COM2 Serial Port test)
1.
System Board
014-XXX-000
(Failed Parallel Port test)
1.
System Board
015-XXX-001
(USB interface not found,
board damaged)
1.
System Board
015-XXX-015
(Failed USB External
Loopback test)
1.
Make sure parallel port is not disabled
2.
Re-run USB External Loopback test
3.
System Board
No Beep Symptom
FRU/Action