IBM x Series 200 User Manual
Page 32
24
Hardware Maintenance Manual: xSeries 200
Error code
(hex)
Description
0x00
Explanation:
The driver could not register the specified interrupt.
Action:
Using the Configuration/Setup Utility program, make sure that a
PCI interrupt is assigned to your Ethernet card, and that Ethernet is enabled.
0x01
Explanation:
One of the PCI cards did not get the required resources.
Action:
Using the Configuration/Setup Utility program, make sure that a
PCI interrupt is assigned to your Ethernet card, and that Ethernet is enabled.
0x02
Explanation:
Bad node address (multicast address).
Action:
Make sure the locally administered address is valid, if one is
specified. The address can not be a multicast address.
0x03
Explanation:
Failed self-test.
Action:
Make sure a cable is attached to the Ethernet connector. If the
problem persists, call for service.
0x0D
Explanation:
Could not allocate enough memory for transmit queues.
Action:
1.
From the Windows NT desktop, select Start
g Control Panel g
Networks
g Adapters.
2.
Select your IBM Ethernet adapter from the list.
3.
Select Properties
g Advanced.
4.
Lower the resource values that apply to the transmit queue.
0x0E
Explanation:
Could not allocate enough memory for receive queue.
Action:
1.
From the Windows NT desktop, select Start
gControl Panel
gNetworks gAdapters.
2.
Select your IBM Ethernet adapter from the list.
3.
Select Properties
gAdvanced.
4.
Lower the resource values that apply to the receive queue.
0x0F
Explanation:
Could not allocate enough memory for other structures.
Action:
1.
From the Windows NT desktop, select Start
g Control Panel g
Networks
g Adapters.
2.
Select your IBM Ethernet adapter from the list.
3.
Select Properties
gAdvanced.
4.
Lower the value for the resource named in the message.
0x10
Explanation:
Did not find any Ethernet controllers.
Action:
Using the Configuration/Setup Utility program, make sure that
Ethernet is enabled.
0x11
Explanation:
Multiple Ethernet controllers found, but none matched the
required ID.
Action:
Using the Configuration/Setup Utility program, make sure that
Ethernet is enabled.
0x13
Explanation:
Did not find any Ethernet controllers that matched the required
subven/subdev.
Action:
Using the Configuration/Setup Utility program, make sure that
Ethernet is enabled.
Table 5. NDIS (Windows NT or Windows 2000) driver messages for the Ethernet
controller.