Intel SE8500HW4 User Manual

Page 27

Intel® Server Board Set SE8500HW4

I/O Subsystems

Revision 1.0

Intel order number D22893-001

3.1.5.3

Hot Removal Example

3.1.5.3.1

Under Microsoft Windows Server 2003, Enterprise Edition:

1. Open the cover of the system to access the adapters and status LEDs.
2. Double-click “Unplug/Eject” in the taskbar to open the “Unplug or Eject Hardware” menu.
3. Select the device to be removed and click “Stop”.
4. Wait for the power LED to turn off.
5. Dis-engage rocker, retention, and/or safety devices.
6. Remove the adapter.

3.1.5.3.2

Under other operating systems:

1. Open the cover of the system to access the adapters and status LEDs.
2. Press the attention button for the slot. (press the attention button within five seconds to abort

the hot plug operation)

3. Wait for the power LED to turn off.
4. Dis-engage rocker, retention, and/or safety devices.
5. Remove the adapter.

3.1.5.4

Hot Addition Example

3.1.5.4.1

Under Microsoft Windows Server 2003, Enterprise Edition:

1. Open the cover of the system to access adapters and view the status LEDs.
2. Install the adapter into the slot.
3. Engage rocker, retention, and/or safety devices.
4. Wait for the software user interface to open. Confirm the device to be enabled.
5. Wait for the power LED to turn on.

Note: If the attention LED is blinking, a power fault has occurred. The user may need to remove
the adapter, wait for the LED to turn off, and re-start the hot add operation.

3.1.5.4.2

Under other operating systems:

1. Open the cover of the system to access adapters and view the status LEDs.
2. Install the adapter into the slot.
3. Engage rocker, retention, and/or safety devices.
4. Press the attention button for the slot. (press the attention within five seconds to abort the

hot plug operation)

5. Wait for the power LED to turn on.
6. Enable the device in your operating system.

Note: If the attention LED is blinking, a power fault has occurred. The user may need to remove
the adapter, wait for the LED to turn off, and re-start the hot add operation.