IBM BladeCenter T Type 8720 - Manual (Page 97)

35. Install the management module(s) at the front of the unit (see “Installing a
management module” on page 53).
36. Install the blade servers at the front of the unit (see “Removing and installing a
blade server or filler module” on page 64).
37. For Type 8720 (dc) units, connect the power cables to the dc terminals. For
Type 8730 (ac) units, plug each power cord into the input power connections
on the rear of the BladeCenter T unit. See “Starting the BladeCenter T unit” on
page 19).
38. Install the power modules at the front of the unit (see “Installing a power
module” on page 48).
39. Install the blade servers (see “Removing and installing a blade server or filler
module” on page 64).
40. Install the I/O modules (see “Removing and installing I/O modules” on page
60).
41. Start up the system (see “Starting the BladeCenter T unit” on page 19).
Chapter 5. Service replaceable units 87