IBM BladeCenter T Type 8720 User Manual

Page 55

background image

1.

Remove

the

bezel

from

the

front

of

the

BladeCenter

T

unit

(see

for

instructions).

2.

Place

the

bezel

front-side

down

on

a

work

surface.

3.

Remove

the

air-filter

retainer

by

pulling

the

retainer

upwards

and

off

the

ball-stud

fasteners

on

the

bezel.

4.

Remove

the

old

air

filter

from

the

bezel

frame.

5.

Remove

the

new

air

filter

from

its

packaging.

LED window

LED holes

Ball-studs

Bezel

Ball-stud clips

LED pipes

Air-filter

Air-filter retainer

6.

Align

the

LED

window

of

the

filter

with

the

holes

for

the

LEDs

on

the

bezel

and

lay

the

filter

into

the

bezel

frame.

7.

Align

the

air-filter

retainer

over

the

filter

with

the

ball-stud

clips

facing

down

and

the

LED

light

pipe

lined

up

with

the

LED

holes

on

the

bezel.

8.

Gently

push

the

air-filter

retainer

down

until

it

snaps

into

the

ball-stud

fasteners

on

the

back

of

the

bezel.

9.

Install

the

bezel

on

the

front

of

the

system

(see

for

instructions).

Chapter

4.

Setting

up

the

BladeCenter

T

hardware

45

This manual is related to the following products:

BladeCenter T Type 8730