MITSUBISHI ELECTRIC PD-5010 User Manual
Page 39
33
Information
PEAK LUMINANCE ENHANCEMENT (PLE)
AUTO .............
The brightness of the screen is
adjusted automatically to suit the
picture quality.
LOCK .............
The brightness level is set to
minimum.
ORBITER
OFF ................
Orbiter mode does not function.
ON ..................
The picture gradually moves around
the screen to reduce the impact of
uneven aging.
INVERSE
OFF ................
Inverse mode does not function.
ON
..................... The picture is displayed alternately
between positive image and negative
image.
You can set the time by pressing the
MENU/ENTER button while “ON”
is set.
WT ..................
The entire screen turns white.
You can set the time by pressing the
MENU/ENTER button while “ON”
is set.
SCREEN WIPER
OFF ................
Screen wiper mode does not function.
ON ..................
Repeatedly moves the white vertical
bar from the left end of the screen to
the right end at a constant speed.
You can set the time by pressing the
MENU/ENTER button while “ON”
is set.
Restoring the factory default settings
To restore the original factory settings, go back to the
MAIN MENU. Select “FUNCTION,”and then select
“RESET”. Note that this also restores other settings to
the factory defaults.
* The PLE and ORBITER can only be adjusted when an
RGB signal is displayed.
5. Once the setting is completed...
Press the EXIT button to return to the FUNCTION
menu.
To exit the main menu, press the EXIT button twice.
Setting the time for “INVERSE”
Set the “INVERSE” or “WHITE” display time and the
“WAITING TIME”.
Example: Setting so that the INVERSE mode cycles
on for 90 minutes and off for 30 minutes.
1. Use the ▲ and ▼ buttons to select “FUNCTION”, then
press the MENU/ENTER button.
The “FUNCTION” screen appears.
2. Use the ▲ and ▼ buttons to select “LONG LIFE”, then
press the MENU/ENTER button.
3. Use the ▲ and ▼buttons to select “INVERSE”, then
use the
and buttons to select “ON”.
L O N G L I F E
: AUTO
: OFF
:
ON
: OFF
RETURN
EXIT
PLE
ORBITER
INVERSE
SCREEN WIPER
SEL.
OK
MENU/ENTER
MENU/ENTER
4. Press the MENU/ENTER button.
The “INVERSE/WT” screen appears.
I N V E R S E / W T
:
ON
SEL.
ADJ.
RETURN
EXIT
WORKING TIME
WORKING TIME
5. Adjust the time using the
and buttons and the ▲
and ▼ buttons.
The mode switches as follows each time the ▲ or ▼
button is pressed.
I N V E R S E / W T
:
1H
: 30M
: 0H
: 30M
SEL.
ADJ.
RETURN
EXIT
WORKING TIME
WAITING TIME
WORKING TIME
WAITING TIME
The 1st line of the “WORKING TIME”:
ON or 0H
1H 2H 3H ... 12H