MITSUBISHI ELECTRIC PD-5010 - Manual (Page 21)

15
STANDARD size screen
The image is expanded in the horizontal and vertical
direction.
WHEN WIDE SIGNALS ARE INPUT
TRUE
The image is true resolution.
STANDARD
The image fills the screen.
Information
Supported resolution
See page 55 for details on the display output of the
various VESA signal standards supported by the
monitor.
“PICTURE SIZE” setting
When the setting of “PICTURE SIZE” is OFF, the
size of RGB-input pictures will be TRUE in place of
NARROW.
When 852 (848) dot x 480 line wide VGA*
signals with a vertical frequency of 60 Hz and
horizontal frequency of 31.7 (31.0) kHz are in-
put
Select an appropriate setting for RGB SELECT mode
referring to the“Table of Signals Supported” on page
55.
* “ IBM PC/AT” and “VGA” are registered trademarks
of IBM, Inc. of the United States.
Watching computer images
Switch to the wide screen mode to expand the 4 : 3 image
to fill the entire screen.
1. Press the FORMAT button on the remote control.
2. Within 3 seconds ...
Press the FORMAT button again.
The screen size switches as follows:
NARROW STANDARD
NARROW size screen (4:3 or SXGA 5:4)
The picture has the same size as the normal computer
image.
STANDARD size screen
The image is expanded in the horizontal direction.
WHEN WIDE SIGNALS ARE INPUT
STANDARD size screen
When “PICTURE SIZE” is set to “OFF”
The screen size switches as follows:
TRUE STANDARD
TRUE size screen (VGA, SVGA 4:3)
The image is true resolution.