MITSUBISHI ELECTRIC PD-5010 - Manual (Page 12)

6
Battery Installation and Replacement
Insert the 2 “AAA” batteries, making sure to set them in
with the proper polarity.
1. Press and open the cover.
2. Align the batteries according to the (+) and (–)
indication inside the case.
3. Replace the cover.
13 INFO
Displays the source settings on the screen.
14 SLEEP
Activates the off timer for the unit.
15 PIP
Press this button to select a screen mode from among
single mode, side by side, and picture in picture.
16 SELECT
Press this button to select the active picture in a multi
screen mode.
17 AUTO POSITION
Press this button to adjust Fine Picture, Picture ADJ,
Position, and Contrast automatically, or to switch the
screen size to ZOOM mode automatically with the
superimposed caption displayed fully only when the
picture contains dark areas above and below the picture.
18 REMOTE CONTROL SIGNAL TRANSMITTER
Transmits the remote control signals.
19 REMOTE JACK
Insert the plug of the supplied remote cable here when
using the supplied remote control in the wired
condition.
* Input is available only after proprietary tuner/controller
has been connected.