MITSUBISHI ELECTRIC R100 - Manual (Page 75)

3. Utilities
R100 Wireless Gateway 75
Chapter 3 - Software Configuration
Printer Setup Wizard
Follow the procedures below to set up your computers to utilise the
printer server function of the R100 Wireless Gateway.
Installing the Printer Driver
Adding a printer to your computer simplifies the R100 Wireless Gateway
Printer Setup Wizard.
You are recommended to install a printer driver through the setup
program that comes with your printer (see following Note), and then
continue to the “Printer Setup Wizard” in the next section. If you run the
“Printer Setup Wizard” without a printer driver installed, you are directed
to the “Add Printer Wizard”.
Note: Some printer setup utilities require a printer to be physically con-
nected to your PC during installation. Follow the driver installation in-
structions to connect your printer to the PC to install the driver and
reconnect the R100 after the printer driver has been installed.
(1) Run the Add Printer Wizard from Start-
-> Settings-->Printers and Faxes -->
Add Printer.
(2) Choose Install by the Add Printer
Wizard.