Metz MF 72TK80 - Manual (Page 8)

8
3. Remote control unit
1. Programming the remote con-
trol unit for control of your
equipment
In order to remotely control your consumer
electronics equipment, you must program-
me each of the various levels of the remote
control unit with a 3-digit code.
• TV (TV-Gerät)
The TV level is already programmed
for Metz TV sets with the type designa-
tion "TH". This programming cannot
be changed.
• VCR 1 (Video recorder 1)
VCR 2 (Video recorder 2)
DVD-Player
HiFi (e.g. amplifier, tuner, tape, etc.)
The remote control unit must be pro-
grammed with a code from the code
list for each level you want to use.
Note the factory settings (Page 6)
and the list of available codes at the
end of these Operating Instructions.
1.1 Programming the codes for
VCR and DVD
When you select the steps a)...c) ,you
have about 15 seconds to continue
with the next step. If you do not do so
within this time, the unit automatically
returns to the TV level
a) Use the Select key to select the desired
level. The coloured LED for the cur-
rently selected level lights.
b) Press the keys and F1 together and
hold them until the LED blinks twice.
c) Enter the desired code (see the code
list) with the numeric keys. If this code
is accepted, the LED again blinks twi-
☞
☞
ce. If the code does not exist in the
table, the LED lights for about two
seconds.
1.2 Programming the codes for
CD Player, Tuner and Tape
When you select the steps a)...c) ,you
have about 15 seconds to continue
with the next step. If you do not do so
within this time, the unit automatically
returns to the TV level.
a) Use the Select key to select the HiFi
level. The coloured LED HiFi lights.
b) Press the key , release it and then
press the key: ...
...F1 for CD player
...F2 for Tuner (radio)
...F3 for Tape (cassette recorders)
der Fernbedienung drücken, bis die
until the LED blinks once.
c) Enter the desired code (see the code
list) with the numeric keys. If this code
is accepted, the LED again blinks twi-
ce. If the code does not exist in the
table, the LED lights for about two
seconds.
1.3 Programming the code for
HiFi amplifier
When you select the steps a)...d) ,you
have about 15 seconds to continue
with the next step. If you do not do so
within this time, the unit automatically
returns to the TV level.
a) Use the Select key to select the HiFi
level. The coloured LED HiFi lights.
b) Press the key , release it and then
press and hold the F3 key until the
LED blinks twice.
☞
☞