Metz MF 72TK80 - Manual (Page 18)

7. Programming stations
You can programme the TV stations in three diffe-
rent ways.
a) Automatic station search
The automatic station search function searches the
entire range of reception frequencies for TV stations.
All stations which are found are placed in the
station table, which is displayed at the end of the
search operation. If you are not satisfied with the
order in which the stations are stored, you can shift
or delete stations as described in the next section.
Executing an automatic station search
• Press the „MENU“ key to call the TV
menu
• Press the red key to open the
„Configuration“ menu.
• Move the cursor to „Automatic station
search“.
• Press the „OK“ key several times until
the message „Searching for stations“
is displayed.
• A station table containing all stations
which are found is displayed on the
left side of the screen.
• At the end of the search, all stations
which were found are sorted and
displayed.
• To delete any unwanted stations, select them
with the cursor and press the „II“ key.
• To save the stations, press the „OK“ key and
enter, with the numeric keys, the number of the
programme position where the first station is to
be saved. The remaining stations are saved in
the following programme positions.
b) Station search
The station search function permits you to search
for specific stations if you do not know their chan-
nel number or frequency.
18
Operation
Function for AV*
Function for F3*
Function for F1*
EURO sockets*
Station search
Country*
Language*
Station search (START)
: select,
OK: go to
settings.
Picture-Volume
AV devices
Station table
Timer
DataLogic
Terr. station search
TV
-Menü
Configuration
Call the menu
MENU
OK
‚ ‚ ‚
* The number of subjects and sections
displayed here depends on the opera-
ting scope setting.