Metz MF 72TK80 - Manual (Page 58)

58
You must use the menu „SAT system“ to inform
the TV set of the settings for the SAT system.
These settings should always be made in the
order indicated by the yellow file cards, i.e. LNB
supply, DiSEqC control, etc.
LNB supply voltage
The LNB supply voltages for selecting the polarisa-
tion (horizontal H = 18 V, vertical V = 12 V) are
fixed and do not normally need to be changed.
If it should be necessary to change these
voltages, note the following setting
sequence.
Changing the settings
• Press the „MENU“ key to open the TV
menu.
• Press the red key to open the menu
„Configuration“.
• Use the cursor control key to select
„SAT system“.
• Use the cursor control key to select „LNB sup-
ply“ and press „OK“ to confirm your selection.
The cursor is now located before the entry „LNB
voltage H“ in the setting window.
• You can now adjust the voltage slightly up (+)
or down (-) with the – + key.
• Press the „OK“ key to save the new setting.
If your TV set is connected to a community
satellite system, the LNB supply voltage
must always be set to „Off“.
☞
24. Sat system
Possible only if a satellite upgrade kit is installed!
Call the menu
MENU
OK
i
Operation
Function for AV*
Function for F3*
Function for F1*
EURO sockets*
Station search
Sat system
Country*
Language*
LNB voltage H 18V+ LNB voltage V 14V-
LNB supply voltage Ein
: select,
OK: go to
settings.
Picture-Volume
AV devices
Station table
Timer
Configuration
LNB freq., sat. A
22kHz signal
DiSEqC system
LNB supply voltage
TV
-Menü
Configuration
‚ ‚ ‚