Metz MF 72TK80 - Manual (Page 61)

61
24. Sat system Call the menu
LNB frequencies for Sat A, Sat B, etc.
The LNB frequencies are used for switching bet-
ween the high band and the low band. In the fac-
tory, these frequencies are set to the standard
values of 9.75 GHz for the low band and
10.60 GHz for the high band.
The settings depend on the components used in
the Sat system. Please consult the data sheets or
the label attached to the LNB(s) for details of the
correct settings.
Setting the LNB frequencies
• Use the cursor control key to select
„LNB freq. Sat A“ and press the „OK“
key to confirm your selection. The cur-
sor is now located before the entry
„Low band“ in the setting window.
• Use the – + key to set the frequency to
the correct value.
• Use the cursor control key to switch to
„High band“ and use the – + key to
set the frequency to the correct value.
• Press the „OK“ key to save the new settings.
OK
Possible only if a satellite upgrade kit is installed!
Operation
Function for AV*
Function for F3*
Function for F1*
EURO sockets*
Station search
Sat system
Country*
Language*
Low band 9,75 GHz High band 10,60 GHz
: select,
OK: go to
settings.
Picture-Volume
AV devices
Station table
Timer
Configuration
LNB freq., sat. B
LNB freq., sat. A
22kHz signal
DiSEqC system
LNB supply voltage
TV
-Menü
Configuration
‚ ‚ ‚