Minolta PageWorks 18L - Manual (Page 35)

2-5
Operational Precautions
Setting-up
Chapter 2
• Never try to modify the printer. Doing so creates the danger of fire
or electrical shock.
• Never place any heavy objects on the power cord, pull on it or
bend it. Doing so creates the danger of fire or electrical shock.
• Always make sure the printer is not placed on the electrical cord or
the communications cables of any other electrical equipment. Also
make sure that cords and cables do not get into the printer’s mech-
anism. Any of these conditions create the danger of malfunction
and fire.
• Always take care so that paper clips, staples, or other small pieces
of metal do not get into the printer through its vents or other open-
ings. Such objects create the danger of fire or electrical shock.
• Do not allow water or other liquids to spill on or near the printer.
Fire or electrical shock can occur should water or liquid come into
contact with the printer.
• Should liquid or any piece of metal accidently get inside the
printer, immediately turn it off, unplug the power cord, and contact
Minolta Technical Support. Failure to take this immediate action
creates the danger of fire or electrical shock.
• Whenever the printer emits unusually high amounts of heat,
smoke, an unusual odor, or noise, immediately turn it off, unplug
it, and contact Minolta Technical Support. Failure to take this
immediate action creates the danger of fire or electrical shock.
Note
• Be sure to locate the printer in a well-ventilated location. A minimal
amount of ozone is generated during normal operation of this printer.
Because of this, an unpleasant odor may result when the printer is used
for extensive printing in a poorly ventilated area. For comfortable, and
safe operation, be sure to locate the printer in a well-ventilated area.