MITSUBISHI ELECTRIC WS-48513 - Manual (Page 38)

38 39
Edit NetCommand ® , Adding an A/V Receiver, continued
A/V Receiver Learn Screen
Figure 9
1. Press ADJUST or on the TV remote to select the
check box for each function to be learned.
2. Press ENT(er) and the function name will begin to flash
to confirm the ready-to-learn status.
3. Press the button on the A/V Receiver’s remote control
that corresponds to the selected function, A check
mark will appear and the function name will stop
flashing. This confirms the signal learned status.
4. To test the learned command, press ENT(er) on the TV
remote. The A/V Receiver will perform the selected
function. The A/V Receiver needs to be turned on
and the IR emitters properly placed for the test to be
successful (see page 26 for IR emitter placement).
5. Repeat for each function to be learned.
6. To erase a learned function, highlight the check box for
that function and press CANCEL.
7. When the function signals have been learned, press
ADJUST to select Next> and move to the Name
screen.
Hint: If your A/V Receiver remote control uses a single
button for both Power On and Power Off, don’t learn the
Power Off function. If your A/V Receiver uses a single
button to toggle between digital and analog sound,
then learn only Analog to Digital. If your A/V Receiver
automatically switches between analog and digital audio,
then you don’t need to learn either Analog to Digital or
Digital to Analog functions
.
A/V Receiver Input Learn Screen
Figure 8
NetCommand can now learn the remote control signals
used to select each input on the A/VReceiver.
1. Press ADJUST or on the TV remote to select the
check box for each function to be learned.
2. Press ENT(er) and the function name will begin to flash
to confirm the ready-to-learn status.
3. Press the button on the A/V Receiver’s remote control
that corresponds to the select function. A check mark
will appear and the function name will stop flashing.
This confirms the signal learned status.
4. To test the learned command, press ENT(er) on the TV
remote. The A/V Receiver will perform the selected
function. The A/V Receiver needs to be turned on
and the IR emitters properly placed for the test to be
successful (see page 26 for IR emitter placement).
5. To customize the input names, press ADJUST to
move to the Input Name text box and then press
ADJUST or and ENT(er) to select each letter of the
name. These names will appear on the Review screen
as the A/V Receiver’s input names.
6. To erase the learned input signal, highlight the check
box for that input and press CANCEL.
7. Repeat for each connected input.
8. When the input selection signals have been learned
and the inputs named, press ADJUST to select
Next> and move to the A/V Receiver Learn screen.
Figure 8. A/V Receiver Input Learn screen Figure 9. A/V Receiver Learn screen