MITSUBISHI ELECTRIC WS-48513 - Manual (Page 22)

22 23
Connecting a DVD Player
DVD Player with Component Video
Figure 9
1. Connect the Component Video cables from
Y/Pr/Pb VIDEO OUT on the back of the DVD player to
COMPONENT-1 on the TV back panel, matching the
correct connection:
• Y to Y
• Pr to Pr
• Pb to Pb
2. Connect a set of audio cables from AUDIO OUT on
the back of the DVD player to COMPONENT-1 AUDIO
Input on the TV back panel. The red cable connects to
the R (right) channel, and the white cable connects to
the L (left) channel.
Satellite Receiver with S-Video
Figure 10
1. Connect an S-Video cable from VIDEO OUT on the
satellite receiver back panel to VIDEO INPUT-2 on the
TV back panel.
2. Connect a set of audio cables from AUDIO OUT on the
satellite receiver back panel to the AUDIO INPUT-2, on
the TV back panel. The red cable connects to the R
(right) channel and the white cable connects to the L
(left) channel.
Note: Refer to the Satellite Receiver Owner’s Guide
for Dish Antenna connections.
(Y/C) L
R
L
R
1 2
VIDEO OUT AUDIO OUT AUDIO IN
Any S-Video Device
White
Red
2
2
1
1
w
h
i
t
e
R
e
d
See Appendix B for component video
signal compatibility information.
For digital audio connections, see your
A/V Receiver, DVD and Satellite Receiver
Owner’s Guides.
IMPORTANT
VIDEO
S
Y
C B
C R
VIDEO OUT
BITSTREAM/PCM 5.1 CH SURROUND 2CH
L
R
CENTER
SUBWOOFER SURROUND FRONT COAXIAL OPTICAL
AUDIO OUT AC IN MITSUBISHI
DVD PLAYER MODEL DD-5000
POWER SUPPLY 120V~ 60Hz POWER CONSUMPTION 20W
MITSUBISHI DIGITAL ELECTRONICS DISTRIBUTED BY
9351 JERONIMO ROAD IRVINE, CA 92618
MADE IN JAPAN
AMERICA, INC.
SERIAL NO. MANUFACTURED
2
Red
DVD back panel
B
A
A
C
2
B
C White
1
1
R
e
d
W
h
i
t
e
Note: NetCommand® assumes you connected
your DVD player to Component 1. If you add a
second DVD or use any other inputs for your DVD,
this change must match in the NetCommand
system. See “Editing NetCommand Setup” in
Chapter 3 for more information.
Note: NetCommand® asssumes you connected
your Satellite Receiver to Input-2. If you add a
second Satellite Receiver or use any other inputs for
your Satellite Receiver, this change must match in the
NetCommand system. See “Editing NetCommand
Setup” in Chapter 3 for more information.
Figure 10. Connecting a Satellite Receiver with S-Video
Figure 9. Connecting a DVD Player with Component Video
Do not display the same stationary images on the screen for more than 15% of your total
TV viewing in one week. Examples of stationary images are letterbox top/bottom bars from DVD or other
video sources, side bars when showing standard TV pictures on widescreen TV’s, stock market reports,
video game patterns, station logos, black or bright Closed caption backgrounds, web sites or stationary
computer images. Such patterns can unevenly age the picture tubes causing permanent damage to the TV.
WARNING:
Connecting a Satellite Receiver with S-Video