Analog codes – Mercedes-Benz CS1000 User Manual
Page 66
1
ANALOG CODES
CS1000 Code Scanner
OB15-11
66
!(# / "
!(# / "
!(# / "
!(# / "
Model
Model Years
124.066
1993-95
Connect wires of Scanner as follows
Scanner
Data Link Connector
Yellow
Power Soft top test connection (4 pole) at Socket 2. The connection is located at the right front
passenger footwell. To avoid the need for an extension cable, connect the black lead of code scanner
to any good ground and red lead to a battery + source inside vehicle.
Black
Socket 1
Red
Socket 16
FAULT CODE TABLE
DTC Readout
Possible Cause of Failure
1
No fault found
2
Volts low
3
Normal operating time exceeded
4
Limit switch signals Illogical
5
Soft top compartment cover "locked", limit switch,
6
Soft top compartment cover "closed", limit switch,
7
Soft top compartment cover "open", limit switch
8
Soft top fabric bow "locked", limit switch
9
Soft top fabric bow "down", limit switch
10
Soft top fabric bow "raised", limit switch
11
Left front soft top "locked", limit switch
12
Right front soft top "locked", limit switch
13
Soft top "open" switch (soft top in storage compartment), limit switch ,
14
Soft top "overhead", limit switch
15
Soft top "retracted", limit switch
16
Roll bar "extended", limit switch,
17
Automatic deployment of roll bar has occurred
18
Power soft top switch
19
Vehicle speed signal
20
Circuit in power soft top control module, solenoid valve, roll bar retracted
21
Circuit hydraulic unit, circuit solenoid valve, roll bar retracted
22
Circuit in power soft top control module, solenoid valve, roll bar extended
23
Circuit solenoid valve, roll bar extended
24
Circuit in power soft top control module, Power windows