Mercedes-Benz CS1000 - Manual (Page 133)

8 - 9 - 10 DM
CS1000 Code Scanner OB15-11
DTC Readout Possible Cause of Failure
133
045 Camshaft position sensor (CMP) signal, fault from Fuel/Ignition control system (left bank in
120)
046 Intake manifold pressure value at start too high/low, fault from Fuel/Ignition control system
(left bank in 120)
047 Not used.
048 Not used.
049 CAN communication faulty in between control units (left bank in 120).
050 Camshaft timing adjust solenoid, open or short circuit (left bank in 120)
051 Fuel injector circuit, open or short circuit or self adaptation at limit. (left bank in 120)
052 Not used.
053 Fuel purge control valve, open or short circuit (left bank in 120)
054 Camshaft position sensor (CMP) signal defective (left bank in 120)
055 Intake manifold pressure sensor signal incorrect, too high/low. (left bank in 120)
056 Crankshaft position sensor (CKP) signal incorrect or starter ring gear segment damaged.
057 Knock sensors circuit or Ignition control module defective (left bank in 120)
058 Not used.
059 Engine coolant temperature (ECT) sensors circuit 1 and 2 have difference values. (left
bank in 120)
060 Engine coolant sensor/Operating temperature error. (left bank in 120)
063 Annomalous Code (Battery Jump most likely Caused)