beautypg.com

Mercedes-Benz CS1000 User Manual

Page 132

background image

8

-

9

-

10

DM

CS1000 Code Scanner

OB15-11

DTC Readout

Possible Cause of Failure

132

013

Camshaft position sensor (CMP) signal, fault from Fuel/Ignition control system (right bank
in 120)

014

Intake manifold pressure value at start too high/low, fault from Fuel/Ignition control system
(right bank in 120)

015

Wide open throttle (WOT) signal incorrect/implausible.

016

Closed throttle position (CTP) sensor signal incorrect/implausible.

017

CAN communication faulty in between control units (right bank in 120).

018

Camshaft timing adjust solenoid, open or short circuit (right bank in 120)

019

Fuel injector circuit, open or short circuit or self adaptation at limit. (right bank in 120)

020

Speed signal missing

021

Fuel purge control valve, open or short circuit (right bank in 120)

022

Camshaft position sensor (CMP) signal defective (right bank in 120)

023

Intake manifold pressure sensor signal incorrect, too high/low. (right bank in 120)

024

Crankshaft position sensor (CKP) signal incorrect or starter ring gear segment damaged.

025

Knock sensors circuit or Ignition control module defective (right bank in 120)

026

Transmission upshift delay switch over valve, open or short circuit.

027

Engine coolant temperature (ECT) sensors circuit 1 and 2 have difference values. (right
bank in 120)

028

Engine coolant sensor/Operating temperature error. (right bank in 120)

034

Oxygen sensor. No signal (left bank in 120)

035

Fuel adaptation (lambda control), inoperative. Engine control module (left bank in 120)

036

Air injection defective, fault from Fuel control system (left bank in 120)

037

EGR exhaust gas recirculation incorrect, fault. Engine control module (left bank in 120)

038

Not used

039

Ignition system defective, fault from Fuel/Ignition control system (left bank in 120)

040

Coolant temperature sensor signal. Open or short circuit (left bank in 120)

041

Intake air temperature sensor signal. Open or short circuit (left bank in 120)

042

Air mass sensor voltage signal too high /low. (left bank in 120)

043

Engine speed signal TN (RPM) or Engine control module (left bank in 120) defective

044

Oxygen sensor heater circuit. Open or short circuit (left bank in 120)