Sanyo Scp 8100 - Manual (Page 16)

Displaying Your Phone Number
Just in case you forget your phone number, your PCS Phone can
remind you.
To display your phone number:
1. Press to access the main menu.
2. Highlight Phone Info and press .
3. Highlight Phone# UserID and press .
ᮣ User ID also appears on the display if you sign in.
Note: To access the phone’s main menu, press from standby
mode. Menu items may be selected by highlighting them with the
Navigation key and pressing
, or you can press the number
corresponding to the menu item on your keypad.
Making and Answering Calls
Making Calls
Your PCS Phone offers many different ways to make calls,
including PCS Voice Command
SM (pages 193-195), Speed Dialing
(pages 92-93), and using Call History (pages 71-75).
To make a call using your keypad:
1. Make sure your phone is on.
2. Enter a phone number. (If you make a mistake while dialing,
press to erase one digit at a time. Press and hold to
erase the entire number.)
3. Press . (To make a call when you are roaming and
Call Guard is enabled, press , highlight Roam Call and
press . See “Call Guard” on page 65.)
4. When you’re finished, press .
Tip: To redial your last outgoing call, press twice.
Tip: When making calls off the enhanced Sprint Nationwide PCS
Network, always dial using 11 digits (1 + area code + phone number).
Section 2: Understanding Your PCS Phone
2A: Your PCS Phone – The Basics 17
Charging the Battery
Your PCS Phone comes with a rechargeable battery. You should
charge the battery as soon as possible so you can begin using
your phone.
Keeping track of your battery’s charge is important. If your
battery level becomes too low, your phone automatically turns
off and you will lose all the information you were just working
on. For a quick check of your phone’s battery level, glance at the
battery charge indicator located in the upper-right corner of
your phone’s display screen. If the battery charge is getting too
low, the battery icon
appears and the phone sounds a
warning tone.
Always use a Sprint-approved desktop charger, travel charger,
or vehicle power adapter to charge your battery.
Warning! Using the wrong battery charger could cause damage to your
phone and void the warranty.
Using the Travel Charger
To use the travel charger provided with your phone:
1. Plug the travel charger into a wall outlet.
2. Plug the other end of the travel charger into the bottom of
your phone (with the battery installed).
ᮣ Charging when your phone is turned on:
The battery icon
appears on the display while charging.
The battery icon turns to when charging is complete.
ᮣ Charging when your phone is turned off:
The battery icon
appears, and the message “BATTERY
CHARGING-Power Off-” is shown on the display while
charging. When the battery is completely discharged, you may
wait for several minutes until the message is shown on the
display. The battery icon turns to
, and message changes to
“CHARGING COMPLETE-Power Off-” when charging is
complete.
It takes approximately 3.5 hours to fully recharge a completely
rundown battery. With the Sprint-approved LiIon battery,
you can recharge the battery before it becomes completely
run down.
Section 2: Understanding Your PCS Phone
16 2A: Your PCS Phone – The Basics