Grizzly VS MILLING MACHINE G0669X - Manual (Page 23)

g0669X precision 10" x 54" Vs Milling Machine
-21-
7. push the emergency stop button, then twist it
clockwise so it pops out. When the emergen-
cy stop button pops out, the switch is reset
and ready for operation (see
figure 22).
Note: Refer to Control Panel on Page 24 for
additional details.
figure 21. Main power switch on back of
electrical cabinet.
Locks
Main
power
switch
Continuous operation of this mill without
properly and successfully completing all
procedures of the Test Run could lead to
personal injury or machine damage, and
could void the warranty.
to test run the machine:
1. Make sure you understand the safety instruc-
tions at the beginning of the manual and that
the machine is setup properly.
2. Make sure all tools and objects used during
setup are cleared away from the machine.
3. Lubricate the mill, as explained in Lubrication
on Page 38.
4. Fill the coolant reservoir (refer to Coolant
Reservoir on Page 40 for detailed instruc-
tions).
5. Connect the machine to the power source.
6. Make sure the electrical cabinet door is
closed and locked, then rotate the main
power switch to the
ON position (see figure
21).
Note: The cooling fans on the back of the
drive system and electrical cabinet should
start.
8. rotate the spindle speed dial all the way to
the left.
9. push the spindle motor on button, then turn
the spindle direction switch to the left or right
to start spindle rotation.
Note: Moving the spindle direction switch to
the center or neutral position stops spindle
rotation.
figure 22. Control panel.
emergency
stop
spindle
direction
spindle
speed
spindle Motor
oFF
spindle
Motor
on
Coolant
pump