Grizzly VS MILLING MACHINE G0669X - Manual (Page 22)

-20-
g0669X precision 10" x 54" Vs Milling Machine
10. Use the cross feed ball handle to move the
table back to the column until you can posi-
tion the front way cover on the saddle ways,
then secure the cover in place with the five
screws shown in
figure 19.
figure 19. Front way cover installed.
screws
11. Move the table to the front until you can posi-
tion the rear way cover over the saddle and
vertical ways, then secure it in place with the
four screws shown in
figure 20.
figure 20. rear way cover installed.
screws
before starting the mill, make sure you
have performed the preceding assembly
and adjustment instructions, and you have
read through the rest of the manual and
are familiar with the various functions and
safety features on this machine. failure to
follow this warning could result in serious
personal injury or even death!
test Run
once the assembly is complete, test run your
machine to make sure it runs properly and is
ready for regular operation.
the test run consists of verifying the follow-
ing:
• the motor powers up and runs correctly.
• the emergency stop button safety feature
works correctly.
• the electrical cabinet safety switch feature
works correctly.
• the emergency spindle brake works cor-
rectly.
if, during the test run, you cannot easily locate
the source of an unusual noise or vibration, stop
using the machine immediately, then review
troubleshooting on Page 43.
if you still cannot remedy a problem, contact our
tech support at (570) 546-9663 for assistance.