Gateway MAN FX510 - Manual (Page 74)

CHAPTER 4: Upgrading Your Computer
68
10 Replace the side panel by following the instructions in
“Replacing the side panel” on page 44 .
Replacing the system board
To replace the system board:
1 Remove the side panel by following the instructions in
“Removing the side panel” on page 41 .
2 For more stability, place your computer on its side. To
avoid scratching the case, place it on a towel or other
non-abrasive surface.
3 Disconnect any cables that are attached to any
expansion cards, noting their locations and orientation.
(You will reconnect the cables after you install the cards
on the new board.)
4 Remove the expansion cards by following the
instructions in
“Adding or replacing an expansion card”
on page 65 . You can slightly seesaw a card end-to-end
to loosen it, but do not bend a card sideways.
Tools
You need a Phillips screwdriver to replace the system board.
8512066.book Page 68 Tuesday, January 16, 2007 11:02 AM