Gateway 860 - Manual (Page 22)

18
Chapter 2: Setting Up
www.gateway.com
Circuit overloading
Appropriate consideration should be given when connecting the supply circuit
to the NAS to avoid any circuit overload. The system nameplate rating should
be used when addressing concerns about circuit overload.
Reliable grounding
To avoid the potential for an electrical shock hazard, the rack assembly itself
must be suitably grounded, according to your local regional electrical codes.
This typically will require the rack to have its own separate ground. We
recommend you consult your local approved electrician.
Electrical shock
Do not operate the NAS unit without the top cover in place. Opening or
removing the cover may expose you to dangerous voltage and can cause
electrical shock.
Battery precautions
There may be a danger of explosion if the CMOS battery is incorrectly replaced.
Replace this battery with model CR2032 only. Use of another battery may
present a risk of fire or explosion. Dispose of used batteries according to
manufacturer's instructions.
Sufficient ventilation
The vents on the front panel and the fan openings on the rear panel provide
ventilation for the NAS. Make sure that these openings are not blocked and
that adequate ventilation is provided where the unit is installed.
Warning Make sure that the site has the necessary capacity to
handle the NAS. Overloading electrical supply circuits is
extremely hazardous.