Grizzly G0716 - Manual (Page 40)

-38-
Model G0716 (Mfg. Since 2/11)
conveyor belt
Replacement
if the conveyor belt becomes excessively worn
or damaged, it can easily be replaced. Contact
grizzly Customer support at 1-800-523-4777 to
obtain a replacement belt (part No. p0706101).
items Needed Qty
phillips screwdriver #2 ...................................... 1
open-End Wrench 10mm .................................. 1
Wrench or socket 13mm ................................... 1
hex Wrench 6mm .............................................. 1
replacement Conveyor Belt .............................. 1
to replace the conveyor belt:
1. disCoNNECt saNdEr FroM poWEr!
2. Fully release the belt tension (see conveyor
belt tension & tracking on page 33 for
detailed instructions).
Note: In the next step, take care to keep the
spacers and washers on the hex bolts in the
same configuration for re-installation.
3. remove the knob and flat washer from the top
of the sanding head support (see figure 39),
remove the hex bolts, spacers, and washers
from the bottom of the support, then remove
the support.
4. remove the two cap screws and flat washers
from the conveyor support (see figure 39).
5. lift the conveyor support up slightly and slip the
conveyor belt off, as shown in figure 40.
figure 40. removing the conveyor belt.
6. after sliding the replacement belt on, replace
the conveyor support cap screws and flat
washers, then re-install the sanding head
support with the fasteners you removed in
Step 3.
7. properly tension the conveyor belt before con-
necting the sander to power (see conveyor
belt tension & tracking on page 33 for
detailed instructions).
figure 39. location of sanding head and
conveyor supports.
sanding
head support
Conveyor
support