Grizzly G0716 - Manual (Page 19)

Model G0716 (Mfg. Since 2/11)
-17-
8. With the help of another person for lifting,
place the sander assembly on the stand,
align the mounting holes, then secure it in
place with (4) M10-1.5 x 30 hex bolts, 10mm
flat washers, and M10-1.5 hex nuts (see
figure 11).
Note: If necessary to align the mounting
holes, slightly loosen the stand fasteners.
Be sure to re-tighten them after securing the
sander assembly.
figure 11. sander assembly secured to the
stand.
x 4
9. thread the handle into the elevation
handwheel, as shown in figure 12.
figure 12. handle installed onto the elevation
handwheel.
Elevation
handwheel
10. install the dust collection elbow into the dust
collection hood, as shown in figure 13.
figure 13. dust collection elbow installed.
Elbow