Grizzly G0716 - Manual (Page 26)

-24-
Model G0716 (Mfg. Since 2/11)
11. release the spring lever—this will allow the
clamp to grab the sandpaper end.
12. While maintaining pressure on the clamp with
your finger as shown in figure 23, remove
the holding pin. then, release the clamp—
this will pull the sandpaper tight.
figure 23. properly securing the sandpaper end.
spring lever
released
Maintaining
pressure
on Clamp
removing
pin
13. Check to make sure the sandpaper strip is
tight against the drum, the edges are not
more than
1 ⁄
8
" apart, and they are not over-
lapped.
— if any of the conditions above are not true,
repeat the installation procedure until they
are.
14. Close and secure the dust collection hood
with the cap screw before connecting the
sander to power.
10. press the spring lever toward the clamp to
open it, then fully insert the end of the sand-
paper strip between the two sides of the
clamp, as shown in
figure 22.
important. Make sure that the sandpaper
end goes inside the clamp—not between the
spring lever and the clamp.
figure 22. inserting the sandpaper end between
the two sides of the clamp.
the sandpaper
goes here.