Grizzly G0716 - Manual (Page 14)

-12-
Model G0716 (Mfg. Since 2/11)
inventory
The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
inventory: (figure 3) Qty
A. drum sander assembly (Not shown) ........ 1
b. left/right long top Braces 23 1 ⁄
8
" .............. 2
c. Wheels 4" ................................................... 2
D. legs ............................................................ 4
E. long Bottom Braces 20 1 ⁄
4
" ......................... 2
f. Elevation handwheel handle ..................... 1
G. leg Foot pads ............................................ 4
h. Wheel axle ................................................. 1
i. dust Collection 90° Elbow 4" ..................... 1
J. lifting handle assemblies .......................... 2
K. left/right Wheel Brackets .................1 Each
L. left/right short top Braces 14 5 ⁄
8
" ............. 2
M. short Bottom Braces 17 1 ⁄
4
" ......................... 2
N. hardware (Not shown)
— Carriage Bolts M8-1.25 x 12 (stand) .... 32
— lock Nuts M8-1.25 (stand) ................... 32
— Cotter pins 4 x 20mm (Wheels).............. 2
— hex Bolts M8-1.25 x 16 (Wheels) ........... 4
— lock Nuts M8-1.25 (Wheels) .................. 4
— Flat head screws M6-1 x 10 (handles) .. 4
— lock Nuts M6-1 (handles) ...................... 4
— hex Bolts M10-1.5 x 30 (sander) ............ 4
— Flat Washer 10mm (sander) ................... 4
— hex Nuts M10-1.5 (sander) ..................... 4
figure 3. small component inventory.
B
C
d
E
F
g
h
i
J
K
l
M